Planning and System Types

What are some good watering systems for allotments?

Good allotment watering systems include water butts and IBCs, gravity drip, solar-pumped drip, leaky hose, ollas and capillary matting. Here's which suits your plot.

On this page
  1. Seven good allotment watering systems
  2. Quick comparison
  3. Which to choose

Good watering systems for allotments are ones that work without mains pressure, electricity or daily visits. The most practical are water butts or IBCs collecting rain from a shed or greenhouse roof, combined with gravity-fed drip, a small solar pump, leaky hose on short runs, or buried ollas for the thirstiest plants. If your plot has its own tap and site rules allow it, a tap timer with drip line works much as it would at home.

Seven good allotment watering systems

1. Water butts or an IBC with a watering can

This is the simplest setup and the foundation of most of the others. Gutter a shed or greenhouse roof into butts or a 1,000-litre IBC, and water by hand.

  • Pros: cheap, reliable, and not affected by hosepipe rules.
  • Cons: hard work, and you have to be there to water.

2. Gravity-fed drip

Low-pressure drip tube runs from a raised butt to the beds. You open the valve when you visit, or use a gravity-rated timer.

  • Pros: no power needed, and it puts water at the roots.
  • Cons: very low pressure. Each metre of height gives only about 0.1 bar, so runs must be short and level.

3. Solar-pumped drip

A small solar panel drives a pump that pushes water from a butt through drippers, often on a built-in schedule.

  • Pros: it waters while you’re away, and it runs most on sunny days, when plants need water most.
  • Cons: costs more, has a limited number of drippers per pump, and the panel may need securing against theft.

4. Leaky (soaker) hose

Porous hose laid along rows, fed from a tap or a raised butt.

  • Pros: very easy to lay, and it suits rows of beans, brassicas or soft fruit.
  • Cons: output is uneven at low pressure and on long runs. See is a weeper hose better than a soaker hose for the differences between porous hoses.

5. Ollas and buried bottles

Unglazed clay pots or pierced bottles buried beside plants and filled on each visit. Water seeps out slowly.

  • Pros: no tubing, works with watering cans, and wastes little water.
  • Cons: each one waters only a small area, and they need refilling.

6. Capillary matting and self-watering trays (greenhouse)

Matting draws water from a reservoir up into pots and module trays on the staging.

  • Pros: keeps seedlings and pots evenly moist for several days.
  • Cons: only works for containers.

7. Tap timer with drip line (if your plot has a tap)

The same setup as a garden system: timer, filter, regulator and dripline.

  • Pros: fully automatic, with even watering.
  • Cons: only possible where there’s a plot tap and site rules allow timers. It may also be restricted during droughts.

Quick comparison

System Needs mains tap? Needs power? Works while away? Effort
Butt and watering can No No No High
Gravity drip No No Partly (with a gravity timer) Low
Solar-pumped drip No Solar Yes Low
Leaky hose Either No With a timer Low
Ollas/bottles No No For a few days Moderate
Capillary matting No No For a few days Low
Tap timer and drip Yes Battery Yes Low

Which to choose

Start by checking your site’s rules and securing as much stored water as you can. If you visit every day or two, gravity drip or leaky hose from a raised butt is often enough. If you visit weekly, a solar pump plus ollas for key crops gives you more of a safety margin.

Our full guide to irrigation systems for allotments covers IBC safety, gravity pressure and which crops to water first. For more low-cost builds, see DIY garden irrigation.

The complete guide to planning and system types

Planning a Garden Irrigation System: How to Choose the Right Setup
Read the guide

Keep exploring

Guides from other topics

All topics →