Yes. If your garden irrigation system connects to a drinking water supply, it needs backflow protection. A backflow preventer stops water that has been sitting in hoses, drip lines or soil, possibly mixed with fertiliser, bacteria or chemicals, from being drawn back into the pipes that supply your taps and your neighbours’. For a simple drip or hose system on an outdoor tap, that often means a check valve or vacuum breaker at the tap, and many newer outdoor taps have one built in. Permanent, buried or fertiliser-fed systems usually need a higher level of protection, set by local regulations.
What backflow is and why it matters
Backflow is water flowing the wrong way, from the garden back into the supply. It happens in two ways:
- Back-siphonage: pressure in the supply drops suddenly, for example from a burst main or firefighting nearby, and suction pulls water back from hoses and pipes.
- Backpressure: pressure on the garden side exceeds supply pressure. This can happen with pumps or with elevated tanks.
Any connection between drinking water and something that isn’t drinking water is called a cross-connection. An irrigation system is one: its emitters and heads sit in soil, puddles and mulch, and it may carry fertiliser. Backflow protection is what keeps that connection safe.
The main types of backflow preventer
| Device | What it protects against | Typical use | Notes |
|---|---|---|---|
| Hose-end vacuum breaker / atmospheric vacuum breaker (AVB) | Back-siphonage | Hose-fed drip and sprinklers on an outdoor tap | Cheap. Generally must not be under constant pressure, and must sit above the highest outlet |
| Single or double check valve (non-testable) | Backflow, at lower hazard levels | Built into many outdoor taps (common in the UK) | Simple. Suitability depends on hazard level and local rules |
| Pressure vacuum breaker (PVB) | Back-siphonage | Permanent sprinkler systems | Can be under constant pressure. Must be above the highest head. Testable |
| Anti-siphon valve | Back-siphonage | Zone valve with a built-in vacuum breaker | One per zone, installed above the highest outlet |
| Testable double check valve assembly | Back-siphonage and backpressure | Permanent systems where permitted | Can go below the highest head. Testable |
| Reduced pressure zone (RPZ) valve | Both, at high hazard levels | Systems with chemical injection, or where local rules demand it | Highest protection. Needs drainage, as it can discharge water. Testable |
| Air gap | Both | Tank-fed systems | A physical gap between the supply outlet and the water it fills. Very effective |
Exact names, approved devices and installation heights differ between countries and water authorities.
Which device suits which setup
- Hose or drip system on an outdoor tap, water only: a tap with a built-in check valve, or a hose-end vacuum breaker or double check valve at the tap, is the usual approach. Fit it before the timer.
- Adding fertiliser through the system: the hazard rises. This usually calls for higher-grade protection, often an RPZ or an air gap, depending on local rules.
- Permanent buried sprinkler system: usually a PVB, a testable double check assembly or an RPZ on the supply to the valves, as local regulations specify.
- Rainwater or well water topped up from the mains: the mains top-up must not connect directly to the tank water. An air gap, with the mains discharging above the tank’s overflow level, is the usual solution.
- Greywater: keep it completely separate from the drinking supply. See using greywater to irrigate your garden safely.
Rules in the UK
In England and Wales, the Water Supply (Water Fittings) Regulations 1999 require fittings to prevent contamination of the public supply, with similar rules in Scotland and Northern Ireland. The regulations classify risks by “fluid category” and specify the backflow protection needed for each.
In practice:
- New outdoor taps are typically supplied with a built-in double check valve to protect against backflow from a hose.
- Irrigation systems that inject fertiliser, or that have buried or permanently installed outlets, can fall into higher-risk categories that need more than a simple check valve.
- You may need to notify your water supplier before installing certain systems, such as automatic garden watering systems not fed by a hand-held hose.
The detail matters, so check with your water supplier or a WRAS-approved plumber before installing a permanent system.
Rules in the US and elsewhere
In the US, backflow requirements are set by states, water utilities and local plumbing codes, and they differ a lot. Some areas accept hose-end vacuum breakers for hose-bib drip systems. Many require a specific device for permanent sprinkler systems. Some require installation by a licensed professional, and annual testing by a certified tester. Contact your water utility or local building department before installing a permanent system. Other countries generally have their own national or local standards.
Where to fit it
For a simple tap-fed system, the common order is:
Tap → backflow device → timer → filter → pressure regulator → tubing
Fitting the backflow device first protects the supply from everything downstream. How to connect a garden irrigation system to an outdoor tap walks through the assembly.
A few placement points:
- Vacuum breakers generally need to sit higher than the highest outlet they protect. Manufacturer and local guidance usually specify a minimum height.
- Devices that can discharge water, such as RPZs, need somewhere for that water to drain, and must never be submerged.
- Devices that aren’t rated for constant pressure shouldn’t sit upstream of a valve that holds pressure against them for long periods.
Testing and maintenance
- Testable devices (PVB, double check assemblies, RPZ) may need periodic testing by a certified tester, depending on where you live.
- In frost-prone areas, drain or remove above-ground devices before winter, because they crack easily when frozen.
- Replace hose-end devices if they leak, stick, or are cracked.
Backflow protection is one of the few parts of a garden irrigation system that protects other people as well as your garden. For where it fits among the other parts, see irrigation system components.