Home Drip Installation

Can you run a drip irrigation system from a rain barrel?

Yes, you can run drip from a rain barrel. Learn why gravity pressure is so low, which emitters and timers work, how to raise the barrel, and when to add a pump.

On this page
  1. The Short Answer
  2. Why Pressure Is the Main Challenge
  3. Parts That Work at Low Pressure
  4. How to Set Up a Rain Barrel Drip System
  5. How Far Will a Barrel of Water Go?
  6. Adding a Pump
  7. Water Quality, Mosquitoes and Local Rules
  8. Troubleshooting

The Short Answer

Yes, you can run a drip irrigation system from a rain barrel, but it works differently from a system on a household tap. A barrel relies on gravity, which produces very little pressure, so you need a raised barrel, a good filter, and drip parts that work at low pressure. Many standard drip parts, especially pressure-compensating emitters and some battery timers, need more pressure than a barrel can supply. For more pressure or a bigger garden, a small pump is the usual answer.

Why Pressure Is the Main Challenge

Water pressure from gravity depends on the height of the water surface above the outlet. Each foot of height gives about 0.43 psi (each metre gives about 0.1 bar).

  • A barrel sitting on the ground, with about 3 feet of water in it, gives at most about 1.3 psi at its base, and less as it empties.
  • Raise that barrel on a 2-foot stand and the water surface is about 5 feet above the garden when full, giving about 2 psi.

A typical household tap supplies something like 40 to 80 psi, and many drip systems run at 15 to 30 psi after a regulator. So a barrel provides a small fraction of the pressure most drip parts are designed for. Flow will be slow, and it will drop as the barrel empties.

Parts That Work at Low Pressure

Part Works with a barrel? Notes
Pressure regulator Leave it out There is no excess pressure to reduce, and a regulator restricts flow
Filter Yes, essential Barrel water carries grit, leaves and organic matter
Non-pressure-compensating emitters Usually yes Flow is lower than rated at low pressure; choose higher-flow or adjustable emitters
Pressure-compensating emitters Often no Many need several psi before they open or compensate; check the minimum pressure
Drip tape and soaker dripline Some products Some are rated for very low pressures; check the specifications
Soaker hose Sometimes Short runs on level ground work best
1/2-inch tubing for the main line Yes Larger tubing loses less of your limited pressure to friction
Battery hose timer Depends Many need a minimum pressure to open; look for timers sold as suitable for gravity or rain barrels

Keep the system small, short and level, or running slightly downhill from the barrel. Every extra foot of tubing and every extra emitter uses up pressure you don’t have.

How to Set Up a Rain Barrel Drip System

  1. Raise the barrel on a solid, level base: concrete blocks, a sturdy stand or a timber platform. A full 55-gallon barrel weighs roughly 460 pounds (about 210 kg), so the base must be stable and the ground firm. Higher gives more pressure, but only if it is safe.
  2. Fit an outlet near the bottom, but a little above the floor of the barrel so you don’t draw sediment into the line. Many barrels have a spigot already.
  3. Add a filter right after the outlet. A screen filter you can open and clean is easiest.
  4. Add a shut-off valve or gravity-suitable timer.
  5. Run 1/2-inch tubing to the bed, keeping it as short as practical.
  6. Install low-pressure emitters, drip tape or soaker dripline on the bed. Fewer, slightly higher-flow outlets often work better than many low-flow ones.
  7. Flush the line with the end open, then cap it.
  8. Test with a full barrel and a half-full one. Check that the last emitter still delivers water when the level drops.

How Far Will a Barrel of Water Go?

One inch of water over a square foot of soil is about 0.62 gallons. A 55-gallon barrel holds enough for roughly 1 inch over about 88 square feet, which is a little under three 4 x 8 foot raised beds. In a dry spell, a single barrel may last only a week or so for a modest vegetable bed. Linking two or more barrels together extends that, and capturing roof runoff refills them after rain.

For more on scheduling, see how often to water a raised vegetable garden.

Adding a Pump

A small submersible or inline pump changes the picture. With a pump you can run a standard drip system, including pressure-compensating emitters and a normal timer. You will then usually need a pressure regulator after the pump, just as you would on a tap. Choose a pump suitable for clean water and for running in a barrel, check that it can’t run dry (some have float switches), and follow electrical safety guidance for outdoor use; solar pump kits are another option. A pump adds cost and complexity, so it makes most sense for larger gardens or where the barrel can’t be raised.

Water Quality, Mosquitoes and Local Rules

  • Water quality: roof runoff can pick up debris, droppings and material from roofing and gutters. Drip helps here, because it applies water to the soil rather than to leaves and fruit. Some guidance suggests extra caution about using roof water on edible crops, so consider your roof type and follow local advice.
  • Mosquitoes: keep the barrel sealed and screen the inlet and overflow with fine mesh.
  • Local rules: rainwater collection is encouraged in many places but regulated or limited in some. Check your local regulations.

Troubleshooting

  • Emitters barely drip: raise the barrel, shorten the line, use fewer or higher-flow emitters, or remove any regulator or pressure-compensating parts.
  • First emitters run, last ones don’t: the line is too long or has too many outlets for the available pressure. Split the bed or feed it from the middle.
  • Flow stops after a while: the filter may be clogged, or the barrel level is too low to push water through.
  • Timer won’t open: it probably needs more pressure than the barrel provides. Use a gravity-rated timer or a manual valve.

For help choosing parts, see the components of a drip irrigation system, and for a cheap overall approach, the cheapest methods of irrigation.

The complete guide to home drip installation

Home Drip Irrigation: Planning and Installing a Garden Drip System
Read the guide

Keep exploring

Guides from other topics

All topics →