Short answer
On most Orbit in-ground sprinkler timers, set the dial to AUTO and press the MANUAL button. The screen typically shows “ALL.” From there you can start a full cycle, or use the arrow keys to pick a single station, set a run time with the +/– buttons, and let it start. Press CLEAR to stop early. Afterward the timer goes back to its normal schedule.
Button names and steps vary between Orbit models, so the details below are a general guide. Check your model’s manual (Orbit publishes timer manuals on its website) if your screen doesn’t match.
Run a single zone from an Orbit dial timer
This is the most common reason for a manual run: testing a zone, or giving one area an extra drink.
- Turn the dial to AUTO (on most models, manual runs start from this position).
- Press MANUAL (on some models it’s labeled ENTER/MANUAL). The display usually shows “ALL.”
- Use the arrow keys to move past the program options until the station number you want is showing.
- Use +/– to set how many minutes the station should run.
- Wait a few seconds, or press ENTER if your model needs it. The station should start.
Most timers only run one station at a time, so starting a manual run may pause or override whatever else is running.
Run all zones or a full program
To run the whole system, for example to check every zone in spring:
- Set the dial to AUTO.
- Press MANUAL so the display shows “ALL.”
- To run a specific program (A, B or C on multi-program models), use the arrow or program button to select it.
- Wait a few seconds or press ENTER. The timer runs each station in turn, using the run times already programmed.
Stations with no programmed run time may be skipped in a full-program manual run. If a zone doesn’t come on, check that it has a run time set.
Stopping a manual cycle
Press CLEAR (or turn the dial to OFF and then back to AUTO on models without a clear button). The timer should cancel the manual run and return to its automatic schedule. Leave the dial on AUTO afterward, or scheduled watering won’t happen.
B-hyve smart timers
On B-hyve Wi-Fi timers, the simplest way to run a zone manually is through the app:
- Open the B-hyve app, select the timer and the zone, and use the manual or quick-run option to choose a run time.
- Some B-hyve timers also have buttons on the unit for starting a manual run without the app. Check your model’s guide.
If the timer is offline, Bluetooth control or the buttons on the unit may still work, depending on the model.
Orbit hose faucet timers
Most Orbit battery hose timers have a manual or “water now” button, or a dial position that opens the valve for a set time. Make sure the tap is fully open before you start. On B-hyve hose timers you can start a manual run from the app or with the button on the unit.
Turning a zone on at the valve
If the controller has no power or has failed, you can usually open an in-ground zone directly at its valve:
- Bleed screw or lever: many valves have a small screw or lever that releases water from the top chamber and opens the valve. Open it slightly and the zone should start.
- Solenoid twist: on many valve designs, turning the solenoid counterclockwise a quarter to half turn opens the valve. Turn it back clockwise until snug to close.
Close the valve the same way when you’re done. Leaving a bleed screw open or a solenoid loose is a common reason sprinklers keep running with the controller off.
If the manual run doesn’t start
- Check that the water supply to the system is on.
- Make sure a rain sensor or rain delay isn’t blocking watering. Some controllers let manual runs override the sensor and some don’t.
- Listen at the valve box for a click. If the zone won’t run manually from the controller but opens at the valve, suspect the wiring or solenoid.
- If no zones will run at all, check the controller’s power, transformer and common wire.
Our Orbit yard watering system troubleshooting guide walks through these checks step by step.